DIGORA OPTIME DRIVERS FREE DOWNLOAD

Insert Control panel assembly. Turn the unit on and start S2terminal Unit does not react to any other inputs than those given by the user through service terminal. Blue led at K board is used as the light source. Tension check and adjustment After that plates can be scanned in manual mode:

Uploader:	Tygotaur
Date Added:	24 August 2010
File Size:	57.43 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	80811
Price:	Free* [*Free Regsitration Required]

The factory calibration fails if the screws are turned! This should happen without errors.

Check the motor connector. SP -Check also that diagnose does not tell about other failures. Service terminal commands and functions are not explained in this manual.

Open Dental Software - Digora Soredex Optime Bridge

Accessory equipment connected to this device must be in compliance with the related nationally harmonized IEC standards. Documentation, trademark and the software are copyrighted with all rights reserved. Symptoms may differ depending on how old the driver is. Check that there is no mechanical reason which prevents linear movement for example image plate or protective covers.

That can happen if vigora motor is running in wrong speed check that the short circuit wire in the motor cable is connected in correct pins. Close Digora, click the Digora button in Open Dental, then open a text editing program and paste so you can see the command Digora adds to the clipboard. Add the drive belt first around the wheel then push the motor holder towards the wheel and slide driverz belt on the motor shaft. This can also happen if the motor belt is adjusted too loose and then the shaft and belt will slip.

Optional Import an image to show on the button 22 x 22 pixels. Icreasing exposure time does not really help. Attach the light cover At other speeds the led is off.

Press start button at K board.

DIGORA Optime DXR-60 Field Service Manual

If found, click the right mouse button and uninstall. Digora for Windows 2. The plate may get stuck on the plate carrier under the ejector. There are no user serviceable parts inside. White from the edges.

DIGORA Optime DXR Field Service Manual |

Insert the light cover Every time an error is caught it is recorded into the service log. XX should now equal to the new firmware version Switch scanner unit off and on to see that there are no errors during start up.

Observe any international, national and local electrical and safety requirements with regards the measurements and connections of the unit to a power supply. Remove the light cover 3. Replaced K board, calibrated and endurance test performed. Error means that driverrs is not closed correctly. Do not use any other numerical parameters after test-command! It should not hit to K board.

Run from Application or other imaging application 2. If led at power adapter does not turn to green check that you get voltage from wall outlet. This is not addressed in the bridge specifications we were provided.